We'd like to swap the 3D printer over to using powerpole connectors, ideally via a Chunzehui F-1012 panel-mount connector block.
We need at least a 6-slot, and the 12 slot would give us room to expand the externally accessible I/O a bit.
About
We are the Kaelars, a found family of goblins (and other creatures) in the Cascadia (and adjacent) bioregions.
We value your input!
We share our knowledge, resources, and library freely with friendlies.
Capitalists, fascists, and other abusers-and-their-apologists can go kick rocks in flip-flops.
We practice the art forms of engineering, woodworking, and general construction,
and dabble in writing, photography, and music,
while holistically pursuing sustainable tech
to enable collaboration and mutual aid, and mutual learning.
We gratefully accept financial contributions towards our family's survival and trajectory towards having enough to share.
You can support our long term efforts via Liberapay (https://liberapay.com/nuneco/) and Patreon (https://www.patreon.com/jakimfett/).